59
C613-50100-01 REV C Command Reference for x930 Series 2869
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP Commands
Introduction
Overview LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the Support for
Allied Telesis Enterprise MIBs in AlliedWare Plus).
The Voice VLAN feature can be configured using commands in VLAN Commands
chapter.
For more information about LLDP, see the LLDP Feature Overview and
Configuration Guide.
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the SNMP Feature Overview and Configuration Guide).
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List •“clear lldp statistics” on page 2871
•“clear lldp table” on page 2872
•“debug lldp” on page 2873
•“lldp faststart-count” on page 2875
•“lldp holdtime-multiplier” on page 2876
•“lldp management-address” on page 2877
•“lldp med-notifications” on page 2878
•“lldp med-tlv-select” on page 2879
•“lldp non-strict-med-tlv-order-check” on page 2882
•“lldp notification-interval” on page 2883
•“lldp notifications” on page 2884
To Next Page
Loading...
Need help?
General
