C613-50100-01 REV C Command Reference for x930 Series 2767
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DHCP FOR IPV6 (DHCPV6) COMMANDS
DOMAIN
-NAME (DHCPV6)
domain-name (DHCPv6)
Overview Use this command in DHCPv6 Configuration mode to add a domain name to the
DHCPv6 server address pool you are configuring.
Use the no variant of this command to remove a domain name from the address
pool.
Syntax
domain-name <domain-name>
no domain-name
Mode DHCPv6 Configuration
Usage This command specifies the domain name that a client should use when resolving
host names using the Domain Name System, and sets the domain name details
using the pre- defined option 15. Note that if you add a user-defined option 15
using the option (DHCPv6) command, then you will override any settings created
with this command.
Examples To add the domain name Engineering to DHCPv6 server pool P2, use the
commands:
awplus# configure terminal
awplus(config)# ipv6 dhcp pool P2
awplus(dhcpv6-config)# domain-name Engineering
To remove the domain name Engineering from DHCPv6 server pool P2, use the
commands:
awplus# configure terminal
awplus(config)# ipv6 dhcp pool P2
awplus(dhcpv6-config)# no domain-name Engineering
Related
Commands
dns-server (DHCPv6)
option (DHCPv6)
show ipv6 dhcp pool
Parameter Description
<domain-name> Specify the domain name you wish to assign the DHCPv6
server address pool. Valid characters are printable characters.
If the name contains spaces then you must enclose it in
“quotation marks”.
To Next Page
Loading...
Need help?
General
