C613-50100-01 REV C Command Reference for x930 Series 1725
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SM COMMANDS
IP
PIM CISCO-REGISTER-CHECKSUM GROUP-LIST
ip pim cisco-register-checksum group-list
Overview Use this command to configure the option to calculate the Register checksum over
the whole packet on multicast groups specified by the access-list. This command
is used to inter-operate with older Cisco IOS versions.
Use the no variant of this command to revert to default settings.
Syntax
ip pim cisco-register-checksum group-list
[<simplerange>|<exprange>|<access-list>]
no ip pim cisco-register-checksum group-list
[<simplerange>|<exprange>|<access-ist>]
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# ip pim cisco-register-checksum group-list 34
awplus(config)# access-list 34 permit 224.0.1.3
Parameter Description
<simplerange> <1-99> Simple access-list.
<exprange> <1300-1999> Simple access-list (expanded range).
<access-list> IP Named Standard Access list.
To Next Page
Loading...
Need help?
General
