C613-50100-01 REV C Command Reference for x930 Series 2643
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF GROUP
show atmf group
Overview This command can be used to display the group membership within to a particular
AMF node. It can also be used with the working-set command to display group
membership within a working set.
Each node in the AMF is automatically added to the group that is appropriate to its
hardware architecture, e.g. x510, x610. Nodes that are configured as masters are
automatically assigned to the master group.
You can create arbitrary groups of AMF members based on your own selection
criteria. You can then assign commands collectively to any of these groups.
Syntax
show atmf group [user-defined|automatic]
Default All groups are displayed
Mode Privileged Exec
Example 1 To display group membership of node2, use the following command:
node2# show atmf group
A typical output screen from this command is shown below:
This screen shows that node2 contains the groups master and x510. Note that
although the node also contains the implicit groups, these do not appear in the
show output.
Example 2 The following commands (entered on node2) will display all the automatic groups
within the working set containing node1 and all nodes that have been pre-defined
to contain the sysadmin group:
First define the working-set:
node1# #atmf working-set node1 group sysadmin
A typical output screen from this command is shown below:
Parameter Description
user-defined User-defined-group information display.
automatic Automatic group information display.
ATMF group information
master, x510
node2#
To Next Page
Loading...
Need help?
General
