C613-50100-01 REV C Command Reference for x930 Series 909
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
SEND
-LIFETIME
send-lifetime
Overview Use this command to specify the time period during which the authentication key
on a key chain can be sent.
Syntax
send-lifetime <start-date> {<end-date>|
duration <seconds>|infinite}
no send-lifetime
Mode Keychain-key Configuration
Example The following example shows the setting of send-lifetime for key 1 on the key
chain named “mychain”.
awplus# configure terminal
awplus(config)# key chain mychain
awplus(config-keychain)# key 1
awplus(config-keychain-key)# send-lifetime 03:03:01 Jan 3 2016
04:04:02 Dec 6 2016
Parameter Description
<start-date> Specifies the start time and date in the format:
<hh:mm:ss> <day> <month> <year> or
<hh:mm:ss> <month> <day> <year>, where:
<hh:mm:ss> The time of the day, in hours, minutes and
seconds
<day> <1-31> The day of the month
<month> The month of the year (the first three letters of
the month, for example, Jan)
<year> <1993-2035> The year
<end-date> Specifies the end time and date in the format:
<hh:mm:ss> <day> <month> <year> or
<hh:mm:ss> <month> <day> <year>, where:
<hh:mm:ss> The time of the day, in hours, minutes and
seconds
<day> <1-31> The day of the month
<month> The month of the year (the first three letters of
the month, for example, Jan)
<year> <1993-2035> The year
<seconds> <1-2147483646> Duration of the key in seconds.
infinite Never expires.
To Next Page
Loading...
Need help?
General
