Allied Telesis AlliedWare Plus - Ipv6 Pim Sparse-Mode Passive

C613-50100-01 REV C Command Reference for x930 Series 1802
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
IPV
6 PIM SPARSE-MODE PASSIVE
ipv6 pim sparse-mode passive
Overview Use this command to enable and disable PIM-SMv6 passive mode operation for
local members on a VLAN interface.
Use the no variant of this command to disable PIM-SMv6 passive mode operation
for local members on a VLAN interface.
Syntax
ipv6 pim sparse-mode passive
no ipv6 pim sparse-mode passive
Mode Interface Configuration for a VLAN interface.
Usage Passive mode essentially stops PIM-SMv6 transactions on the interface, allowing
only the MLD mechanism to be active.
Examples
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 pim sparse-mode passive
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ipv6 pim sparse-mode passive