EasyManua.ls Logo

Allied Telesis AlliedWare Plus - Ipv6 Pim Register-Rp-Reachability

Allied Telesis AlliedWare Plus
3082 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C613-50100-01 REV C Command Reference for x930 Series 1792
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
IPV
6 PIM REGISTER-RP-REACHABILITY
ipv6 pim register-rp-reachability
Overview Use this command to enable the RP reachability check for PIMv6 Register
processing at the DR. The default setting is no checking for RP-reachability.
Use the no variant of this command to disable this processing.
Syntax
ipv6 pim register-rp-reachability
no ipv6 pim register-rp-reachability
Default This command is disabled; by default, there is no checking for RP-reachability.
Mode Global Configuration
Examples
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# ipv6 pim register-rp-reachability
awplus# configure terminal
awplus(config)# no ipv6 pim register-rp-reachability

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Related product manuals