Allied Telesis AlliedWare Plus - Restart Rip Graceful

C613-50100-01 REV C Command Reference for x930 Series 905
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIP COMMANDS
RESTART
RIP GRACEFUL
restart rip graceful
Overview Use this command to force the RIP process to restart, and optionally set the
grace-period.
Syntax
restart rip graceful [grace-period <1-65535>]
Mode Privileged Exec
Default The default RIP grace-period is 60 seconds.
Usage After this command is executed, the RIP process immediately shuts down. It
notifies the system that RIP has performed a graceful shutdown. Routes that have
been installed into the route table by RIP are preserved until the specified
grace-period expires.
When a restart rip graceful command is issued, the RIP configuration is reloaded
from the last saved configuration. Ensure you first enter the command copy
running-config startup-config.
When a master failover happens on a VCStack, the RIP grace-period will apply the
larger value of either the setting's configured value, or its default of 60 seconds.
Example To apply a restart rip graceful setting, grace-period to 100 seconds use the
following commands:
awplus# copy running-config startup-config
awplus# restart rip graceful grace-period 100