C613-50100-01 REV C Command Reference for x930 Series 2520
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ETHERNET PROTECTION SWITCHED RING (EPSRING™) COMMANDS
SHOW
EPSR
show epsr
Overview This command displays information about all EPSR instances.
Syntax
show epsr
Mode User Exec and Privileged Exec
Example To show the current settings of all EPSR instances, use the command:
awplus# show epsr
Output:
non-superloop
topology
The following examples show the output display for a non-superloop topology
network.
Table 1: Example output from the show epsr command run on a transit node
EPSR Information
------------------------------------------------------------
Name .......................... test2
Mode .......................... Transit
Status ........................ Enabled
State ......................... Links-Up
Control Vlan .................. 2
Data VLAN(s) .................. 10
Interface Mode ................ Ports Only
First Port .................... port1.0.1
First Port Status ............. Down
First Port Direction .......... Unknown
Second Port ................... port1.0.2
Second Port Status ............ Down
Second Port Direction ......... Unknown
Trap .......................... Enabled
Master Node ................... Unknown
Enhanced Recovery ............. Disabled
------------------------------------------------------------
To Next Page
Loading...
Need help?
General
