Allied Telesis AlliedWare Plus - Chapter 45: RADIUS Commands; Introduction; RADIUS Commands

45
C613-50100-01 REV C Command Reference for x930 Series 2251
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RADIUS Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
the device to use RADIUS servers.
Command List •“auth radius send nas-identifier” on page 2252
•“auth radius send service-type” on page 2253
•“deadtime (RADIUS server group)” on page 2254
•“debug radius” on page 2255
•“ip radius source-interface” on page 2256
•“radius-server deadtime” on page 2257
•“radius-server host” on page 2258
•“radius-server key” on page 2261
•“radius-server retransmit” on page 2262
•“radius-server timeout” on page 2264
•“server (Server Group)” on page 2266
•“show debugging radius” on page 2268
•“show radius” on page 2269
•“show radius statistics” on page 2272
•“undebug radius” on page 2273