Allied Telesis AlliedWare Plus - Show Ip Bgp (BGP Only)

C613-50100-01 REV C Command Reference for x930 Series 1392
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
SHOW
IP BGP (BGP ONLY)
show ip bgp (BGP only)
Overview Use this command to display BGP network information.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip bgp [<ip-addr>|<ip-addr/m>]
Mode User Exec and Privileged Exec
Example
awplus# show ip bgp 10.10.1.34/24
Output Figure 28-7: Example output from the show ip bgp command
Related
Commands
neighbor remove-private-AS (BGP only)
Parameter Description
<ip-addr>
<ip-addr/m>
Specifies the IPv4 address and the optional prefix mask length.
BGP table version is 7, local router ID is 80.80.80.80
Status codes: s suppressed, d damped, h history, * valid, > 
best, i - internal, S Stale
Origin codes: i - IGP, e - EGP, ? - incomplete

Network Next Hop Metric LocPrf Weight 
Path
S>i10.70.0.0/24 192.10.23.67 0 100 0 ?
S>i30.30.30.30/32 192.10.23.67 0 100 0 ?
S>i63.63.63.1/32 192.10.23.67 0 100 0 ?
S>i67.67.67.67/32 192.10.23.67 0 100 0 ?
S>i172.22.10.0/24 192.10.23.67 0 100 0 ?
S>i192.10.21.0 192.10.23.67 0 100 0 ?
S>i192.10.23.0 192.10.23.67 0 100 0 ?

Total number of prefixes 7