C613-50100-01 REV C Command Reference for x930 Series 2902
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
LOCATION
COORD-LOCATION-ID
location coord-location-id
Overview Use this command to assign a coordinate location to the ports. The coordinate
location must already exist. This replaces any previous assignment of coordinate
location for the ports. Up to one location of each type can be assigned to a port.
Use the no variant of this command to remove a location from the ports.
Syntax
location coord-location-id <coord-loc-id>
no location coord-location-id [<coord-loc-id>]
Default By default no coordinate location is assigned to ports.
Mode Interface Configuration
Usage The coordinate location associated with a port can be transmitted in Location
Identification TLVs via the port.
Before using this command, configure the location using the following
commands:
• location coord-location identifier command
• location coord-location configuration command
If a coordinate location is deleted using the no variant of the location
coord-location identifier command, it is automatically removed from all ports.
Examples To assign coordinate location 1 to port1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# location coord-location-id 1
To remove a coordinate location from port1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no location coord-location-id
Related
Commands
lldp med-tlv-select
location coord-location identifier
location coord-location configuration
show location
Parameter Description
<coord-loc-id> Coordinate location ID, in the range 1 to 4095.
To Next Page
Loading...
Need help?
General
