Allied Telesis AlliedWare Plus - Show System Pluggable

C613-50100-01 REV C Command Reference for x930 Series 316
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PLUGGABLES AND CABLING COMMANDS
SHOW
SYSTEM PLUGGABLE
show system pluggable
Overview This command displays brief pluggable transceiver information showing the
pluggable type, the pluggable serial number, and the pluggable port on the
device. Different types of pluggable transceivers are supported in different models
of device. See your Allied Telesis dealer for more information about the models of
pluggables that your device supports.
Syntax
show system pluggable [<port-list>]
Mode User Exec and Privileged Exec
Example To display brief information about all installed pluggable transceivers, use the
command:
awplus# show system pluggable
Example To display brief information about pluggable transceivers installed in port1.0.25
through port1.0.26, use the command:
awplus# show system pluggable port1.0.25-1.0.26
Output Figure 8-3: Example output from show system pluggable port1.0.25-1.0.26
Parameter Description
<port-list> The ports to display information about. The port list can be:
• a switch port (e.g. port1.0.25)
• a continuous range of ports separated by a hyphen (e.g.
port1.0.27-1.0.28)
• a comma-separated list of ports and port ranges (e.g.
port1.0.25,port1.0.27-1.0.28)
System Pluggable Information
Port Manufacturer Device Serial Number Datecode Type
--------------------------------------------------------------------------------
1.0.25 AGILENT HFBR-5710L 0401312315461272 040131 1000BASE-SX
1.0.26 AGILENT QBCU-5730R AK0614GKF7 060408 1000BASE-T
--------------------------------------------------------------------------------
Table 9: Parameters in the output from the show system pluggable command
Parameter Description
Stack member The stack member number.
Port Specifies the vendor’s name for the installed pluggable
transceiver.