Allied Telesis AlliedWare Plus - Show Ipv6 Pim Sparse-Mode Local-Members

C613-50100-01 REV C Command Reference for x930 Series 1812
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
SHOW
IPV6 PIM SPARSE-MODE LOCAL-MEMBERS
show ipv6 pim sparse-mode local-members
Overview Use this command to show detailed local member information on a VLAN interface
configured for PIM-SMv6. If you do not specify a VLAN interface then detailed local
member information is shown for all VLAN interfaces configured for PIM-SMv6.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 pim sparse-mode local-members [<interface>]
Mode User Exec and Privileged Exec
Example To show detailed PIM-SMv6 information for all PIM-SMv6 configured VLAN
interfaces, use the command:
awplus# show ipv6 pim sparse-mode local-members
Output Figure 35-5: Example output from the show ipv6 pim sparse-mode
local-members command
Example To show detailed PIM-SMv6 information for the PIM-SMv6 configured interface
vlan1, use the command:
awplus# show ipv6 pim sparse-mode local-members vlan1
Parameter Description
<interface> Optional Specify the interface. For instance, VLAN interface vlan2.
awplus#show ipv6 pim sparse-mode local-members 
PIM Local membership information 

vlan1: 

(*, ff02::1:ff6b:4783) : Include 

vlan203: 

(*, ff0e:1::4) : Include 
