C613-50100-01 REV C Command Reference for x930 Series 2493
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRRP COMMANDS
SHOW
VRRP IPV6
show vrrp ipv6
Overview Use this command to display information about all configured VRRPv3 IPv6
sessions for all interfaces, or all VRRPv3 IPv6 sessions for a given interface with the
optional parameter.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
See the VRRP Feature Overview and Configuration Guide for more information
about VRRPv3 IPv6 configuration details.
Syntax
show vrrp ipv6 [<interface>]
Mode User Exec and Privileged Exec
Example To display information about all VRRPv3 IPv6 sessions, enter the command:
awplus# show vrrp ipv6
Output Figure 52-6: Example output from the show vrrp ipv6 vlan2 command
Related
Commands
enable (VRRP)
disable (VRRP)
Parameter Description
<interface> Specify the name of the interface that will participate in the virtual
routing. The interface must exist on the router. The interface
specified sends and receives VRRPv3 IPv6 advertisement messages.
awplus#show vrrp ipv6 vlan2
VrId <1>
State is Master
Virtual IP is fe80::202:b3ff:fed5:983e (Owner)
Interface is vlan2
Priority is 255
Advertisement interval is 4 sec
Preempt mode is FALSE