C613-50100-01 REV C Command Reference for x930 Series 2823
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
NTP COMMANDS
SHOW
NTP COUNTERS
show ntp counters
Overview This command displays packet counters for NTP.
Syntax
show ntp counters
Mode User Exec and Privileged Exec
Example To display counters for NTP use the command:
awplus# show ntp counters
Figure 57-1: Example output from show ntp counters
uptime: 7212
sysstats reset: 7212
packets received: 307
current version: 237
older version: 69
bad length or format: 0
authentication failed: 0
declined: 0
restricted: 0
rate limited: 0
KoD responses: 0
processed for time: 306
Table 57-1: Parameters in the output from show ntp counters
Parameter Description
uptime How long NTP has been running since it was last restarted, in
seconds.
sysstats reset How long since show ntp status information was last reset, in
seconds.
packets
received
Total number of NTP client and server packets received by the
device.
current
version
The number of version 4 NTP packets received.
older version The number of NTP packets received that are from an older
version, down to version 1, of NTP. NTP is compatible with these
versions and processes these packets.
bad length or
format
The number of NTP packets received that do not conform to the
standard packet length. NTP drops these packets.
To Next Page
Loading...
Need help?
General
