19
C613-50100-01 REV C Command Reference for x930 Series 688
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
GVRP Commands
Introduction
Overview With GVRP enabled the switch can exchange VLAN configuration information with
other GVRP enabled switches. VLANs can be dynamically created and managed
through trunk ports.
• There is a limit of 400 VLANs supported by the AlliedWare Plus GVRP
implementation. VLANs may be numbered 1-4094, but a limit of 400 of these
VLANs are supported.
• MSTP is not supported by the AlliedWare Plus GVRP implementation. GVRP
and MSTP are mutually exclusive. STP and RSTP are supported by GVRP.
• VCStack is not supported by the current AlliedWare Plus GVRP
implementation.
This chapter provides an alphabetical reference for commands used to configure
GVRP. For information about GVRP, including configuration, see the GVRP Feature
Overview and Configuration Guide.
Command List •“clear gvrp statistics” on page 690
•“debug gvrp” on page 691
•“gvrp (interface)” on page 693
•“gvrp dynamic-vlan-creation” on page 694
•“gvrp enable (global)” on page 695
•“gvrp registration” on page 696
•“gvrp timer” on page 697
•“show debugging gvrp” on page 699
•“show gvrp configuration” on page 700
•“show gvrp machine” on page 701
•“show gvrp statistics” on page 702
To Next Page
Loading...
Need help?
General
