C613-50100-01 REV C Command Reference for x930 Series 687
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
POWER OVER ETHERNET COMMANDS
SHOW
POWER-INLINE INTERFACE DETAIL
Related
Commands
show power-inline
show power-inline interface
Detection of
legacy
devices is
[Enabled|Disabled]
The status of legacy PoE detection on the PoE port, as configured
for the PoE port with the power-inline allow-legacy command.
Powered
pairs:
[Data|Spare]
The IEEE 802.3af and IEEE 802.3at standards allow for either data
or spare twisted pairs to be used to transfer power to a PD.
The powered pairs status for each port. AlliedWare Plus™ PoE
switches implement IEEE 802.3af and IEEE 802.3at Endpoint PSE
Alternative A (Data).
Table 4: Parameters in show power-inline interface detail command output
Parameter Description
To Next Page
Loading...
