C613-50100-01 REV C Command Reference for x930 Series 2628
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF AREA NODES
show atmf area nodes
Overview Use this command to display summarized information about an AMF controller’s
remote nodes.
Note that this command can only be run from a controller node.
Syntax
show atmf area nodes [<area-name> [<node-name>]]
Mode Privileged Exec
Usage If you do not limit the output to a single area or node, this command lists all remote
nodes that the controller is aware of. This can be a very large number of nodes.
Example To show summarized information about all the nodes the controller is aware of,
use the command:
controller-1# show atmf area nodes
The following figure shows partial example output from running this command.
Parameter Description
<area-name> Displays information about nodes in the specified area.
<node-name> Displays information about the specified node.
Table 11: Output from the show atmf area nodes command
controller-1#show atmf area nodes
Wellington Area Node Information:
Node Device ATMF Node
Name Type Master SC Parent Depth
----------------------------------------------------------------------------
well-gate x210-24GT N N well-master 1
well-master AT-x930-28GPX Y N none 0
Wellington node count 2
...
Table 12: Parameter definitions from the show atmf area nodes command
Parameter Definition
Node Name The name assigned to a particular node.
Device Type The Product series name.
To Next Page
Loading...
Need help?
General
