56
C613-50100-01 REV C Command Reference for x930 Series 2754
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DHCP for IPv6
(DHCPv6)
Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
DHCPv6. For more information, see the DHCPv6 Feature Overview and
Configuration Guide.
DHCPv6 is a network protocol used to configure IPv6 hosts with IPv6 addresses and
IPv6 prefixes for an IPv6 network. DHCPv6 is used instead of SLAAC (Stateless
Address Autoconfiguration) at sites where centralized management of IPv6 hosts
is needed. IPv6 routers require automatic configuration of IPv6 addresses and IPv6
prefixes.
DHCPv6 Prefix Delegation provides automatic configuration of IPv6 addresses and
IPv6 prefixes.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
NOTE: The IPv6 addresses shown use the address space 2001:0db8::/32, defined in RFC
3849 for documentation purposes. These addresses should not be used for practical
networks (other than for testing purposes) nor should they appear on any public
network.
Command List •“address prefix” on page 2756
•“address range” on page 2758
•“clear counter ipv6 dhcp-client” on page 2760
•“clear counter ipv6 dhcp-server” on page 2761
•“clear ipv6 dhcp binding” on page 2762
•“clear ipv6 dhcp client” on page 2764
•“dns-server (DHCPv6)” on page 2765
•“domain-name (DHCPv6)” on page 2767
•“ip dhcp-relay agent-option subscriber-id-auto-mac” on page 2768
To Next Page
Loading...
Need help?
General
