C613-50100-01 REV C Command Reference for x930 Series 1428
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
SHOW
IP PROTOCOLS BGP (BGP ONLY)
show ip protocols bgp (BGP only)
Overview Use this command to display BGP process parameters and statistics.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip protocols bgp
Mode User Exec and Privileged Exec
Example To display BGP process parameters and statistics, use the command:
awplus# show ip protocols bgp
Output Figure 28-16: Example output from the show ip protocols bgp command
Routing Protocol is "bgp 100"
IGP synchronization is disabled
Automatic route summarization is disabled
Default local-preference applied to incoming route is 100
Redistributing:
Neighbor(s):
Address AddressFamily FiltIn FiltOut DistIn DistOut RouteMapIn RouteMapOut
Weight
10.10.10.1 unicast
To Next Page
Loading...
Need help?
General
