C613-50100-01 REV C Command Reference for x930 Series 1918
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST EXTENDED TCP UDP FILTER)
Example 2
[adding to a list]
To insert a new entry with sequence number 5 of the access-list named my-list
that will accept UDP packets from 10.1.1.0/24 network to 192.168.1.0/24
network on UDP port 80, use the commands:
awplus# configure terminal
awplus(config)# access-list extended my-list
awplus(config-ip-ext-acl)# 5 permit udp 10.1.1.0/24
192.168.1.0/24 eq 80
To Next Page
Loading...
