Allied Telesis AlliedWare Plus - Page 2206

C613-50100-01 REV C Command Reference for x930 Series 2206
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AAA COMMANDS
AAA
ACCOUNTING AUTH-MAC
• group <group-name>: use the specified RADIUS server group configured
with the aaa group server command
The accounting event to send to the RADIUS server is configured with the
following options:
• start-stop: sends a start accounting message at the beginning of a session
and a stop accounting message at the end of the session.
• stop-only: sends a stop accounting message at the end of a session.
• none: disables accounting.
Examples To enable the default RADIUS accounting for MAC-based authentication, and use
all available RADIUS servers, use the commands:
awplus# configure terminal
awplus(config)# aaa accounting auth-mac default start-stop
group radius
To disable RADIUS accounting for MAC-based Authentication, use the commands:
awplus# configure terminal
awplus(config)# no aaa accounting auth-mac default
To enable a named RADIUS accounting method list 'vlan10_acct' for MAC-based
authentication, with the RADIUS server group 'rad_group_vlan10, use the
commands:
awplus# configure terminal
awplus(config)# aaa accounting auth-mac vlan10_acct start-stop
group rad_group_vlan10
To disable a named RADIUS accounting method list 'vlan10_acct' for MAC-based
authentication, use the commands:
awplus# configure terminal
awplus(config)# no aaa accounting auth-mac vlan10_acct
Related
Commands
aaa authentication auth-mac
aaa group server
auth-mac accounting
auth-mac enable
radius-server host
show aaa server group