C613-50100-01 REV C Command Reference for x930 Series 2751
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
SHOW
IP DHCP SERVER STATISTICS
Related
Commands
show counter dhcp-server
service dhcp-server
show ip dhcp binding
show ip dhcp pool
DHCPRELEASE in The number of Release messages received by the
DHCP server.
DHCPINFORM in The number of Inform messages received by the
DHCP server.
DHCPOFFER out The number of Offer messages sent by the DHCP
server.
DHCPACK out The number of Acknowledgement messages sent
by the DHCP server.
DHCPNAK out The number of Negative Acknowledgement
messages sent by the DHCP server. The server
sends these after receiving a request that it cannot
fulfil because either there are no available IP
addresses in the related address pool, or the
request has come from a client that doesn’t fit the
network setting for an address pool.
BOOTREQUEST in The number of bootp messages received by the
DHCP server from bootp clients.
BOOTREPLY out The number of bootp messages sent by the DHCP
server to bootp clients.
DHCPLEASEQUERY in The number of Lease Query messages received by
the DHCP server from DHCP Relay Agents.
DHCPLEASEUNKNOWN out The number of Lease Unknown messages sent by
the DHCP server to DHCP Relay Agents.
DHCPLEASEACTIVE out The number of Lease Active messages sent by the
DHCP server to DHCP Relay Agents.
DHCPLEASEUNASSIGNED
out
The number of Lease Unassigned messages sent by
the DHCP server to DHCP Relay Agents.
Table 4: Parameters in the output of the show ip dhcp server statistics
command (cont.)
Parameter Description
To Next Page
Loading...
Need help?
General
