C613-50100-01 REV C Command Reference for x930 Series 2920
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
SHOW
LLDP NEIGHBORS DETAIL
Table 61: Parameters in the output of the show lldp neighbors detail command
Parameter Description
Chassis ID Type Type of the Chassis ID.
Chassis ID Chassis ID that uniquely identifies the
neighbor.
Port ID Type Type of the Port ID.
Port ID Port ID of the neighbor.
TTL Number of seconds that the information
advertised by the neighbor remains valid.
Port Description Port description of the neighbor’s port.
System Name Neighbor’s system name.
System Description Neighbor’s system description.
System Capabilities
(Supported)
Capabilities that the neighbor supports.
System Capabilities
(Enabled)
Capabilities that are enabled on the
neighbor.
Management Addresses List of neighbor’s management addresses.
Port VLAN ID (PVID) VLAN identifier associated with untagged or
priority tagged frames for the neighbor port.
Port & Protocol VLAN
(Supported)
Whether Port & Protocol VLAN is supported
on the LLDP neighbor.
Port & Protocol VLAN
(Enabled)
Whether Port & Protocol VLAN is enabled on
the LLDP neighbor.
Port & Protocol VLAN (VIDs) List of Port & Protocol VLAN identifiers.
VLAN Names List of names of VLANs that the neighbor’s
port belongs to.
Protocol IDs List of protocols that are accessible through
the neighbor’s port.
MAC/PHY Auto-negotiation Auto-negotiation configuration and status
Power Via MDI (PoE) PoE configuration and status of 802.3 Power-
Via-MDI TLV
Link Aggregation Link aggregation information
To Next Page
Loading...
Need help?
General
