C613-50100-01 REV C Command Reference for x930 Series 116
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
Similarly, you can specify the USB storage device base directory with usb or usb:
or usb:/
You cannot name a directory or subdirectory flash, nvs, usb, card, tftp, scp, sftp
or http. These keywords are reserved for tab completion when using various file
commands.
In a stacked environment you can only access flash and nvs using the stack
member filepath (e.g. dir awplus-2/flash:/). To access a USB storage
device on a backup stack member, use the remote-login command.
Command List •“autoboot enable” on page 118
•“boot config-file” on page 119
•“boot config-file backup” on page 121
•“boot system” on page 122
•“boot system backup” on page 124
•“cd” on page 125
•“copy (filename)” on page 126
•“copy current-software” on page 128
•“copy debug” on page 129
•“copy running-config” on page 130
•“copy startup-config” on page 131
•“copy zmodem” on page 132
•“create autoboot” on page 133
•“delete” on page 134
•“delete debug” on page 135
•“dir” on page 136
•“edit” on page 138
•“edit (filename)” on page 139
•“erase startup-config” on page 140
•“ip tftp source-interface” on page 141
•“
ipv6 tftp source-interface” on page 142
•“mkdir” on page 143
•“move” on page 144
•“move debug” on page 145
•“pwd” on page 146
•“rmdir” on page 147
•“show autoboot” on page 148
•“show boot” on page 149
To Next Page
Loading...
Need help?
General
