Allied Telesis AlliedWare Plus - Page 123

C613-50100-01 REV C Command Reference for x930 Series 123
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
BOOT
SYSTEM
To run the release file x930-5.4.6-1.1.rel stored on the switch’s USB storage device
filesystem the next time the device boots up, use the commands:
awplus# configure terminal
awplus(config)# boot system usb:/x930-5.4.6-1.1.rel
To remove the release file x930-5.4.6-1.1.rel stored on the switch’s USB storage
device filesystem the next time the device boots up, use the commands:
awplus# configure terminal
awplus(config)# boot system usb:/x930-5.4.6-1.1.rel
In a VCStack configuration, if there is not enough space to synchronize the new
release across the stack, the boot system command has an interactive mode that
prompts you to delete old releases.
awplus# configure terminal
awplus(config)# boot system x930-5.4.6-1.1.rel
Answering “y” at the prompt will cause the system to delete the specified file:
awplus(config)# y
Related
Commands
boot config-file
boot config-file backup
boot system backup
show boot
Insufficient flash available on stack member-2 (11370496)
to synchronize file x930-5.4.6-1.1.rel 
(14821895).

List of release files on stack member-2
x930-5.4.6-0.1.rel (14822400)

Select files to free up space,
Delete awplus-2/flash:/x930-5.4.6-0.1.rel? (y/n)[n]:y
Deleting selected files, please wait............................
Successful operation
VCS synchronizing file across the stack, please wait.............
File synchronization with stack member-2 successfully completed
[DONE]