C613-50100-01 REV C Command Reference for x930 Series 1248
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
ACTIVATE
Examples
[BGP4+]
To enable an exchange of routes in IPv6 Address Family Configuration mode with
a neighboring router with the IPv6 address 2001:0db8:010d::1, enter the
commands as shown below:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# address-family ipv6
awplus(config-router-af)# neighbor 2001:0db8:010d::1 activate
To disable an exchange of routes in IPv6 Address Family Configuration mode with
a neighboring router with the IPv6 address 2001:0db8:010d::1, enter the
commands as shown below:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# address-family ipv6
awplus(config-router-af)# no neighbor 2001:0db8:010d::1
activate
To enable an exchange of routes with a neighboring router with the peer-group
named group1, enter the commands as shown below:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# neighbor group1 peer-group
awplus(config-router)# neighbor 2001:0db8:010d::1 remote-as 10
awplus(config-router)# address-family ipv6
awplus(config-router-af)# neighbor 2001:0db8:010d::1
peer-group group1
awplus(config-router-af)# neighbor group1 activate
To disable an exchange of routes with a neighboring router with the peer-group
named group1, enter the commands as shown below:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# address-family ipv6
awplus(config-router-af)# no neighbor group1 activate
Related
Commands
neighbor peer-group (add a neighbor)
neighbor route-map
To Next Page
Loading...
Need help?
General
