Allied Telesis AlliedWare Plus - Page 1352

C613-50100-01 REV C Command Reference for x930 Series 1352
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
UPDATE-SOURCE
Examples
[BGP4+]
To source BGP connections for neighbor 2001:0db8:010d::1 with the IPv6 address
of the local loopback address instead of the best local address, enter the
commands listed below:
awplus(config)# interface lo
awplus(config-if)# ipv6 address 2001:0db8:010d::1/128
awplus(config-if)# exit
awplus(config)# router bgp 100
awplus(config-router)# neighbor 2001:0db8:010d::1 remote-as 110
awplus(config-router)# neighbor 2001:0db8:010d::1
update-source lo
To remove BGP connections for neighbor 2001:0db8:010d::1 with the IPv6 address
of the local loopback address instead of the best local address, enter the
commands listed below:
awplus(config)# router bgp 100
awplus(config-router)# no neighbor 2001:0db8:010d::1
update-source
To source BGP connections for neighbor group1 with the IPv6 address of the local
loopback address instead of the best local address, enter the commands listed
below:
awplus(config)# interface lo
awplus(config-if)# ipv6 address 2001:0db8:010d::1/128
awplus(config-if)# exit
awplus(config)# router bgp 100
awplus(config-router)# neighbor group1 peer-group
awplus(config-router)# neighbor 2001:0db8:010d::1 remote-as 100
awplus(config-router)# address-family ipv6
awplus(config-router-
af)# neighbor 2001:0db8:010d::1 peer-group group1
awplus(config-router-
af)# exit
awplus(config-router)# neighbor group1 update-source lo
To remove BGP connections for neighbor group1 with the IPv6 address of the local
loopback address instead of the best local address, enter the commands listed
below:
awplus(config)# router bgp 100
awplus(config-router)# neighbor group1 update-source lo
Related
Commands
neighbor peer-group (add a neighbor)
neighbor route-map