Allied Telesis AlliedWare Plus - Page 1367

C613-50100-01 REV C Command Reference for x930 Series 1367
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
ROUTE
-MAP (ROUTE MAP)
If it finds a match on a route map with an action of permit, then it applies any set
clauses and accepts the route. Having found a match, the route is not compared
against any further entries of the route map.
If it finds a match on a route map with an action of deny, it will discard the
matching route.
If it does not find a match, it discards the routeor update message. This means that
route maps end with an implicit deny entry. To permit all non-matching routesor
update messages, end your route map with an entry that has an action of permit
and no match clause.
Examples To enter route-map mode for entry 1 of the route map called route1, and then
add a match and set clause to it, use the commands:
awplus# configure terminal
awplus(config)# route-map route1 permit 1
awplus(config-route-map)# match as-path 60
awplus(config-route-map)# set weight 70
To enter route-map mode for entry 2 of the route map called route1, and then
add a match and set clause to it, use the commands:
awplus# configure terminal
awplus(config)# route-map route1 permit 2
awplus(config-route-map)# match interface vlan2
awplus(config-route-map)# set metric 20
Note how the prompt changes when you go into route map configuration mode.
To make the device process non-matching routes instead of discarding them, add
a command like the following one:
awplus(config)# route-map route1 permit 100
Related
Commands
bgp dampening
neighbor default-originate
neighbor route-map
neighbor unsuppress-map
network (BGP and BGP4+)
redistribute (into BGP or BGP4+)
show ip bgp route-map (BGP only)
show route-map (Route Map)