Allied Telesis AlliedWare Plus - Page 1370

C613-50100-01 REV C Command Reference for x930 Series 1370
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
SET
COMMUNITY (ROUTE MAP)
Mode Route-map Configuration
Usage This command is valid for BGP update messages only.
Examples To use entry 3 of the route map called rmap1 to put matching routes into the no-
advertise community, use the commands:
awplus# configure terminal
awplus(config)# route-map rmap1 permit 3
awplus(config-route-map)# set community no-advertise
To use entry 3 of the route map called rmap1 to put matching routes into several
communities, use the commands:
awplus# configure terminal
awplus(config)# route-map rmap1 permit 3
awplus(config-route-map)# set community 10:01 23:34 12:14
no-export
To use entry 3 of the route map called rmap1 to put matching routes into a single
AS community numbered 16384, use the commands:
awplus# configure terminal
awplus(config)# route-map rmap1 permit 3
awplus(config-route-map)# set community 16384 no-export
Related
Commands
match community (Route Map)
route-map (Route Map)
none The device removes the community attribute from matching
update messages.
additive The device adds the specified community value to the update
message’s community attribute, instead of replacing the existing
attribute. By default this parameter is not included, so the device
replaces the existing attribute.
Parameter Description