C613-50100-01 REV C Command Reference for x930 Series 1530
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRF LITE COMMANDS
REDISTRIBUTE
(INTO BGP OR BGP4+)
To apply the above example to a specific VRF instance named blue, use the
following commands:
awplus(config)# router bgp 12
awplus(config-router)# address-family ipv4 vrf blue
awplus(config-router-af)# redistribute ospf route-map rmap1
The following example shows the configuration of a route-map named rmap2,
which is then applied using the redistribute route-map command.
awplus# configure terminal
awplus(config)# route-map rmap2 permit 3
awplus(config-route-map)# match interface vlan1
awplus(config-route-map)# set metric-type 1
awplus(config-route-map)# exit
awplus(config)# router ospf 100
awplus(config-router)# redistribute bgp route-map rmap2
Note that configuring a route-map and applying it with the redistribute route-map
command allows you to filter which router are distributed from another routing
protocol (such as OSPF with BGP). A route-map can also set the metric, tag, and
metric-type of the redistributed routes.
To Next Page
Loading...
