Allied Telesis AlliedWare Plus User Manual

C613-50100-01 REV C Command Reference for x930 Series 1620
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP SNOOPING TCN QUERY SOLICIT
See the IGMP Feature Overview and Configuration Guide for introductory
information about the Query Solicitation feature.
NOTE: This command will function on the switch in the stand-alone mode, but it is not
supported when the device forms part of a VCS Stack.
Examples To enable Query Solicitation on a device, use the commands:
awplus# configure terminal
awplus(config)# ip igmp snooping tcn query solicit
To disable Query Solicitation on a device, use the commands:
awplus# configure terminal
awplus(config)# no ip igmp snooping tcn query solicit
To enable Query Solicitation for vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip igmp snooping tcn query solicit
To disable Query Solicitation for vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ip igmp snooping tcn query solicit
Related
Commands
ip igmp query-holdtime
show ip igmp interface
show running-config
Command
issued from
Global
Configuration
Command issued
from Interface
Configuration
Device is STP Root
Bridge or the
EPSR Master Node
IGMP Query Solicit
message sent on VLAN
No Yes Yes Yes
Yes No Yes No
Yes Yes Yes Yes

Allied Telesis AlliedWare Plus Specifications

General

Brand	Allied Telesis
Model	AlliedWare Plus
Category	Switch
Language	English