C613-50100-01 REV C Command Reference for x930 Series 1740
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SM COMMANDS
IP
PIM RP-ADDRESS
Only Permit filters in ACL are considered as valid group ranges. The default
Permit filter 0.0.0.0/0 is converted to the default multicast filter
224.0.0.0/4.
After configuration, the RP-address is inserted into a static-RP group tree based on
the configured group ranges. For each group range, multiple static-RPs are
maintained in a linked list. This list is sorted in a descending order of IP addresses.
When selecting static- RPs for a group range, the first element (which is the
static-RP with highest IP address) is chosen.
RP-address deletion is handled by removing the static-RP from all the existing
group ranges and recalculating the RPs for existing TIB states if required.
Group mode and RP address mappings learned through BSR take precedence over
mappings statistically defined by the ip pim rp-address command. Commands
with the override keyword take precedence over dynamically learned mappings.
Example
awplus# configure terminal
awplus(config)# ip pim rp-address 192.168.3.4 4
Related
Commands
ip pim rp-candidate
ip pim rp-register-kat
To Next Page
Loading...
Need help?
General
