C613-50100-01 REV C Command Reference for x930 Series 1882
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST HARDWARE IP PROTOCOL FILTER)
Mode IPv4 Hardware ACL Configuration
Default Any traffic on an interface controlled by a hardware ACL that does not explicitly
match a filter is permitted.
Usage First create a named hardware access-list that applies the appropriate permit/deny
requirements. Then use the access-group command to apply this access-list to a
specific port or range. Note that this command will apply the access-list only to
incoming data packets.
An ACL can be configured with multiple ACL filters using sequence numbers. If the
sequence number is omitted, the next available multiple of 10 will be used as the
sequence number for the new filter. A new ACL filter can be inserted into the
middle of an existing list by specifying the appropriate sequence number.
NOTE: The access control list being configured is selected by running the access-list
hardware (named) command. with the required access control list number, or name,
but with no further parameters selected.
Hardware ACLs will permit access unless explicitly denied by an ACL action.
54 NARP (NBMA Address Resolution Protocol) [RFC1735]
58 ICMP for IPv6 [RFC1883]
59 No Next Header for IPv6 [RFC1883]
60 Destination Options for IPv6 [RFC1883]
88 EIGRP (Enhanced Interior Gateway Routing Protocol)
89 OSPFIGP [RFC1583]
97 Ethernet-within-IP Encapsulation / RFC3378
98 Encapsulation Header / RFC1241
108 IP Payload Compression Protocol / RFC2393
112 Virtual Router Redundancy Protocol / RFC3768
134 RSVP-E2E-IGNORE / RFC3175
135 Mobility Header / RFC3775
136 UDPLite / RFC3828
137 MPLS-in-IP / RFC4023
138 MANET Protocols / RFC-ietf-manet-iana-07.txt
139-252 Unassigned / IANA
253 Use for experimentation and testing / RFC3692
254 Use for experimentation and testing / RFC3692
255 Reserved / IANA
Table 37-2: IP protocol number and description (cont.)
Protocol Number Protocol Description [RFC]