C613-50100-01 REV C Command Reference for x930 Series 1902
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
ACCESS
-LIST EXTENDED (NAMED)
<destination> The destination address of the packets. You can specify a single
host, a subnet, or all destinations. The following are the valid
formats for specifying the destination:
any Matches any destination IP address.
host<ip-addr> Matches a single destination host with the
IP address given by <ip-addr> in dotted
decimal notation.
<ip-addr>/
<prefix>
An IPv4 address, followed by a forward
slash, then the prefix length. This matches
any destination IP address within the
specified subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a reverse mask
in dotted decimal format. For example,
entering 192.168.1.1 0.0.0.255 is
the same as entering 192.168.1.1/24.
log Logs the results.
<ip-protocol> The IP protocol number, as defined by IANA (Internet Assigned
Numbers Authority
www.iana.org/assignments/protocol-numbers)
See below for a list of IP protocol numbers and their descriptions.
Table 38-5: IP protocol number and description
Protocol Number Protocol Description [RFC]
1 Internet Control Message [RFC792]
2 Internet Group Management [RFC1112]
3 Gateway-to-Gateway [RFC823]
4 IP in IP [RFC2003]
5 Stream [RFC1190] [RFC1819]
6 TCP (Transmission Control Protocol) [RFC793]
8 EGP (Exterior Gateway Protocol) [RFC888]
9 IGP (Interior Gateway Protocol) [IANA]
11 Network Voice Protocol [RFC741]
17 UDP (User Datagram Protocol) [RFC768]
20 Host monitoring [RFC869]
27 RDP (Reliable Data Protocol) [RFC908]
28 IRTP (Internet Reliable Transaction Protocol) [RFC938]
Table 38-4: Parameters in the access-list extended (named) command -
proto|ip|any (cont.)
Parameter Description
To Next Page
Loading...
Need help?
General
