C613-50100-01 REV C Command Reference for x930 Series 1926
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST STANDARD NUMBERED FILTER)
Usage An ACL can be configured with multiple ACL filters using sequence numbers. If the
sequence number is omitted, the next available multiple of 10 will be used as the
sequence number for the new filter. A new ACL filter can be inserted into the
middle of an existing list by specifying the appropriate sequence number.
NOTE: The access control list being configured is selected by running the access-list
(standard numbered) command with the required access control list number but with
no further parameters selected.
Software ACLs will deny access unless explicitly permitted by an ACL action.
Example To add a new entry accepting the IP network 10.1.1.0/24 at the sequence
number 15 position, use the commands:
awplus# configure terminal
awplus(config)# access-list 99
awplus(config-ip-std-acl)# 15 permit 10.1.2.0 0.0.0.255
Related
Commands
access-list (standard numbered)
show running-config
show ip access-list
To Next Page
Loading...
Need help?
General
