C613-50100-01 REV C Command Reference for x930 Series 1956
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV6 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(IPV6 ACCESS-LIST NAMED PROTOCOL FILTER)
Default Any traffic on an interface controlled by a hardware ACL that does not explicitly
match a filter is permitted.
Usage This command adds a hardware classification filter (for use with features such as
QoS), to a current standard IPv6 access-list. The filter will match on any IP protocol
type packet that has the specified source and destination IPv6 addresses and the
specified IP protocol type. The parameter any may be specified if an address does
not matter,
NOTE: Hardware ACLs will permit access unless explicitly denied by an ACL action.
Examples To add a filter entry to the ACL named “my-acl” to deny IGMP packets from
2001:0db8::0/64 , use the commands:
awplus# configure terminal
awplus(config)# ipv6 access-list my-acl
awplus(config-ipv6-hw-acl)# deny proto 2 2001:0db8::0/64 any
To remove a filter entry that blocks IGMP packets from network 2001:0db8::0/64
from the ACL named “my-acl”, use the commands:
awplus# configure terminal
awplus(config)# ipv6 access-list my-acl
awplus(config-ipv6-hw-acl)# no deny proto 2 2001:0db8::0/64 any
Related
Commands
ipv6 access-list (named)
(ipv6 access-list named ICMP filter)
(ipv6 access-list named IPv6 filter)
(ipv6 access-list named TCP UDP filter)
ipv6 traffic-filter
show ipv6 access-list (IPv6 Hardware ACLs)
To Next Page
Loading...
Need help?
General
