C613-50100-01 REV C Command Reference for x930 Series 1958
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV6 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(IPV6 ACCESS-LIST NAMED TCP UDP FILTER)
send-to-cpu Specifies the packets to send to the CPU.
Specifying this parameter could result in EPSR
healthcheck messages and other control packets
being dropped.
send-to-mirror Specifies the packets to send to mirror port.
copy-to-cpu Specifies the packets to copy to the CPU.
copy-to-mirror Specifies the packets to copy to the mirror port.
tcp Specifies a TCP packet.
udp Specifies a UDP packet.
<ipv6-source-prefix/
prefix-length>
Specifies the source address with mask.
The IPv6 address prefix uses the format
X:X::/prefix-length. The prefix-length is usually set
between 0 and 64.
<ipv6-source-address> Specifies the source address.
The IPv6 address uses the format X:X::X:X.
<ipv6-source-wildcard> Specifies the source wildcard bits in IPv6 format
X:X::X:X.
host <ipv6-source-host> Specifies the a single source host.
The IPv6 address uses the format X:X::X:X.
any Specifies any Source host. An abbreviation for the
IPv6 prefix ::/0.
eq Equal to.
lt Less than.
gt Greater than.
ne Not equal to.
<sourceport> The source port number, specified as an integer
between 0 and 65535.
<destport> The destination port number, specified as an
integer between 0 and 65535.
range Range of port numbers. Match only packets
within range.
<start-range> The port number at the start of the range
<0-65535>.
<end-range> The port number at the end of the range
<0-65535>.
<ipv6-dest-prefix/
prefix-length>
Specify destination address with mask.
The IPv6 address prefix uses the format
X:X::/prefix-length. The prefix-length is usually set
between 0 and 64.
<ipv6-destination-
address>
Specify destination address.
The IPv6 address uses the format X:X::X:X.
Parameter Description
To Next Page
Loading...
Need help?
General
