C613-50100-01 REV C Command Reference for x930 Series 1980
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV6 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
IPV
6 ACCESS-LIST STANDARD (NAMED)
For backwards compatibility you can either create IPv6 standard access-lists from
within this command, or you can enter ipv6 access-list standard
followed by only the IPv6 standard access-list name. This latter (and preferred)
method moves you to the (config-ipv6-std-acl) prompt for the selected
IPv6 standard access-list, and from here you can configure the filters for this
selected IPv6 standard access-list.
NOTE: Software ACLs will deny access unless explicitly permitted by an ACL action.
Example To enter the IPv6 Standard ACL Configuration mode for the access-list named
my-list, use the commands:
awplus# configure terminal
awplus(config)# ipv6 access-list standard my-list
awplus(config-ipv6-std-acl)#
Related
Commands
(ipv6 access-list standard filter)
show ipv6 access-list (IPv6 Software ACLs)
show running-config
To Next Page
Loading...
Need help?
General
