C613-50100-01 REV C Command Reference for x930 Series 2032
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
QOS COMMANDS
SHOW
MLS QOS INTERFACE
Egress Queue: 3
Status: Enabled
Scheduler: Strict Priority
Egress Queue: 4
Status: Enabled
Scheduler: Strict Priority
Egress Queue: 5
Status: Enabled
Scheduler: Strict Priority
Egress Queue: 6
Status: Enabled
Scheduler: Strict Priority
Egress Queue: 7
Status: Enabled
Scheduler: Strict Priority
Table 42: Parameters in the output of the show mls qos interface command
Parameter Description
Default CoS The default CoS priority that will be applied to all packets
arriving on this interface.
Default Queue The default queue that will be applied to all packets
arriving on this interface.
Number of egress
queues
The total number of egress queues available on this
interface.
Egress Queue X Number of this egress queue.
Status Queue can either be enabled or disabled.
Scheduler The scheduling mode being used for servicing the
transmission of packets on this port.
Queue Limit The percentage of the port’s buffers that have been
allocated to this queue.
Egress Rate Limit The amount of traffic that can be transmitted via this
queue per second. 0 Kb means there is currently no
rate-limiting enabled.
To Next Page
Loading...
