C613-50100-01 REV C Command Reference for x930 Series 2337
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PUBLIC KEY INFRASTRUCTURE COMMANDS
CRYPTO
SECURE-MODE
If you wish to leave secure mode, you should delete all sensitive information first.
This means deleting all trustpoints (one by one), then deleting all public/private
key pairs, then turning off secure mode. Use the commands:
awplus# configure terminal
awplus(config)# no crypto pki trustpoint <name>
awplus(config)# crypto key zeroize all
awplus(config)# no crypto secure-mode
awplus(config)# exit
awplus# write
awplus# reboot
The switch must be rebooted after secure mode is turned off, and ideally Flash
memory should be erased via the bootloader.
Related
Commands
crypto key zeroize
crypto pki trustpoint
To Next Page
Loading...
Need help?
General
