C613-50100-01 REV C Command Reference for x930 Series 2413
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OPENFLOW COMMANDS
SHOW
OPENFLOW CONFIG
Related
Commands
openflow controller
openflow native vlan
show openflow status
Controller The IPv4 address of the OpenFlow controller and TCP port
number
fail_mode The fail mode. When the fail mode is “secure,” OpenFlow
on the switch does not set up flows when the OpenFlow
controller fails.
is_connected Whether or not the OpenFlow controller is connected
Port The port information
Interface The interface of the port.
type: The type of the port
options: The options for the port
Table 50-1: Parameters in the output from show openflow config (cont.)
Parameter Description
To Next Page
Loading...
