C613-50100-01 REV C Command Reference for x930 Series 2424
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
CAUTION: Stack operation is only supported if stack virtual-mac is enabled. For more
information refer to stack virtual-mac on page 2460
Command List •“clear counter stack” on page 2425
•“debug stack” on page 2426
•“mac address-table vcs-sync-mode” on page 2427
•“reboot rolling” on page 2428
•“reload rolling” on page 2429
•“remote-command (deleted)” on page 2430
•“remote-login” on page 2431
•“show counter stack” on page 2432
•“show debugging stack” on page 2436
•“show running-config stack” on page 2437
•“show provisioning (stack)” on page 2438
•“show stack” on page 2439
•“show stack detail” on page 2441
•“show stack indicator” on page 2445
•“show stack resiliencylink” on page 2446
•“stack disabled-master-monitoring” on page 2448
•“stack enable” on page 2449
•“stack management subnet” on page 2450
•“stack management vlan” on page 2451
•“stack priority” on page 2452
•“stack renumber” on page 2453
•“stack renumber cascade” on page 2454
•“stack resiliencylink” on page 2456
•“stack software-auto-synchronize” on page 2458
•“stack virtual-chassis-id” on page 2459
•“stack virtual-mac” on page 2460
•“switch provision (stack)” on page 2461
•“switchport resiliencylink” on page 2462
•“vlan mode stack-local-vlan” on page 2463
•“undebug stack” on page 2465
To Next Page
Loading...
Need help?
General
