C613-50100-01 REV C Command Reference for x930 Series 2440
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
SHOW
STACK
Related
Commands
show stack detail
show counter stack
show stack resiliencylink
stack disabled-master-monitoring
stack resiliencylink
stack software-auto-synchronize
Priority Stack member master election priority (between 0 and 255). Note
that the lowest number has the highest priority.
Role Stack member’s role in the stack, this can be one of:
• Active Master
• Disabled Master— this is the temporary master when there is a
communication break within the stack, but communication still
exists across the resiliency link. In this state all switch ports within
the stack are disabled by default, but a different configuration can
be run by a “type stack disabled-master” trigger.
• Backup Member— a device other than the stack master.
• Provisioned— indicates that the stack position is provisionally
configured, i.e. ready to accept a particular switch type into the
stack.
Table 3: Parameters in the output from the show stack command (cont.)
Parameter Description
To Next Page
Loading...
Need help?
General
