C613-50100-01 REV C Command Reference for x930 Series 2610
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
DEBUG
ATMF PACKET
To enable send and receive 500 packets only on vlink1 for packet types 1, 7, and 11,
use the command:
node_1# debug atmf packet num-pkts 500 filter interface vlink1
pkt-type 1 7 11
This example applies the debug atmf packet command and combines many of its
options:
node_1# debug atmf packet direction rx level 1 num-pkts 60
filter node x610 interface port1.0.1 pkt-type 4 7 10
To Next Page
Loading...
