C613-50100-01 REV C Command Reference for x930 Series 2770
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DHCP FOR IPV6 (DHCPV6) COMMANDS
IPV
6 ADDRESS (DHCPV6 PD)
In this example, the prefix will be assigned from the pool on the PD client. The host
portion or suffix will be ::1 for the last 64 bits.
To configure a PD prefix named prefix1 on interface vlan1 and then add an IPv6
address using EUI-64 identifiers, use the following commands:
awplus# configure terminal
awplus(config)# interface vlan1
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 dhcp client pd prefix1
awplus(config-if)# ipv6 address prefix1/64 eui64
In this example, the prefix will be assigned from the pool on the PD client. The host
portion or suffix is created from the EUI-64 identifier of the interface for the last 64
bits.
To assign the IPv6 address 2001:0db8::a2/48 to the VLAN interface vlan2, use the
following commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 address 2001:0db8::a2/48
To remove the IPv6 address 2001:0db8::a2/48 from the VLAN interface vlan2, use
the following commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ipv6 address 2001:0db8::a2/48
To assign the IPv6 address to the PPP interface ppp0, use the following
commands:
awplus# configure terminal
awplus(config)# interface ppp0
awplus(config-fr-subif)# ipv6 address 2001:0db8::a2/64
To remove the IPv6 address 2001:0db8::a2/64 from the PPP interface ppp0, use the
following commands:
awplus# configure terminal
awplus(config)# interface ppp0
awplus(config-if)# no ipv6 address 2001:0db8::a2/64
To assign the eui64 derived address in the prefix 2001:db8::/64 to VLAN
interface vlan2, use the following commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 address 2001:0db8::/64 eui64
To Next Page
Loading...
Need help?
General
