C613-50100-01 REV C Command Reference for x930 Series 2851
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SNMP COMMANDS
SNMP
-SERVER ENABLE TRAP
Default By default, no notifications are generated.
Mode Global Configuration
Usage This command cannot be used to enable link status notifications globally. To
enable link status notifications for particular interfaces, use the snmp trap
link-status command.
To specify where notifications are sent, use the snmp-server host command.
Note that more than one trap can be configured with one command entry, and
also note this command applied to notifications send by SNMP version 3.
Examples To enable the device to send a notification if an AMF node changes its status, use
the following commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap atmfnode
To enable the device to send PoE related traps, use the following commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap power-inline
To disable PoE traps being sent out by the device, use the following commands:
awplus# configure terminal
awplus(config)# no snmp-server enable power-inline
To enable the device to send MAC address Thrash Limiting traps, use the following
commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap thrash-limit
To disable the device from sending MAC address Thrash Limiting traps, use the
following commands:
awplus# configure terminal
awplus(config)# no snmp-server enable trap thrash-limit
To enable the device to send OSPF and VRRP-related traps, use the following
commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap ospf vrrp
thrash-limit MAC address Thrash Limiting traps.
vcs VCS traps.
vrrp Virtual Router Redundancy (VRRP) traps.
Parameter Description
To Next Page
Loading...
Need help?
General
