C613-50100-01 REV C Command Reference for x930 Series 3056
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PING-POLLING COMMANDS
SHOW
PING-POLL
Poll 2:
Description : Secondary Gateway
Destination IP address : 192.168.0.100
Status : Up
Enabled : Yes
Source IP address : Default
Critical interval : 5
Normal interval : 60
Fail count : 20
Up count : 30
Sample size : 100
Length : 56
Timeout : 2
Debugging : Enabled
Table 67: Parameters in output of the show ping-poll command
Parameter Description
Description Optional description set for the polling instance with the
description (ping-polling) command.
Destination
IP address
The IP address of the polled device, set with the ip (ping-polling)
command.
Status The current status of the device being polled:
Up The device is reachable.
Down The device is unreachable.
Critic
a l Up
The device is reachable but recently the polling
instance has not received some ping replies, so the
polled device may be going down.
Critic
a l
Down
The device is unreachable but the polling instance
received a reply to the last ping packet, so the
polled device may be coming back up.
Enabled Whether the polling instance is enabled or disabled. The active
(ping-polling) and active (ping-polling) commands enable and
disable a polling instance.
Source IP
address
The source IP address sent in the ping packets. This is set using
the source-ip command.
Critical
interval
The time period in seconds between pings when the polling
instance has not received a reply to at least one ping, and when
the device is unreachable. This is set with the critical-interval
command.
Normal
interval
The time period between pings when the device is reachable.
This is set with the normal-interval command.
To Next Page
Loading...
Need help?
General
