C613-50100-01 REV C Command Reference for x930 Series 3069
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SFLOW COMMANDS
SFLOW
COLLECTOR (ADDRESS)
To set the sFlow collector address to 2001:0db8::1 and leave the UDP port
unchanged, use the command:
awplus# configure terminal
awplus(config)# sflow collector ipv6 2001:0db8::1
To remove the sFlow collector IPv6 address and leave the UDP port unchanged,
use the command:
awplus# configure terminal
awplus(config)# no sflow collector ipv6
To remove the sFlow collector IPv6 address and to remove the UDP port, use the
command:
awplus# configure terminal
awplus(config)# no sflow collector ipv6 port
Related
Commands
show running-config sflow
show sflow
To Next Page
Loading...
